P3_06_Qinglan luo_Offset Loose

-Open Grasshopper.

-Draw a surface in Rhino.

-Connect the surface with “srf” in Grasshooper.

-Select “Offset Loose” which under “Surface”.

-Drop line from “Srf”, plug into “S” on “Offset Losse”.

-Double clink, type in “Slider”, select “Number Slider”.

-Drop line from “Slider” plug into “D” on “Offset Loose”, change the range of slinder.

-Then could see a surface could be move out of the basic surface.

If I set an “Explode” tool I can see the point on each angle of that surface, but I did not figure out how to make those point moved individually. So I did not change the surface.

Comments are closed.